Das STUDER und ReVox Forum

Hello STUDER fans!

Does anyone know how to connect directly to 1.924.560 talkback box to 961?
I think it's possible to connect the talkback box to the rear 961 connectors: MONITOR and AUX1/AUX2 CR.

Has anyone tried it?

Thank you very much.

viewfinder

Cr and studio monitor boxes are only passive units. Just follow the documentation, i.e. the different sub-D pin layouts in the manual and build the needed adaptor. Signal names are more or less clearly explaining what it is. The docu on studers ftp server is a little bit low scan quality but if you received a manual with your 961 you should find anything needed.

Thanks wernerl

'm trying, but not all signals are well explained in
documentation.

Thank again.

Best regards.

viewfinder

as i have no other documentation than the pdf from the ftp server it is difficult to help (and 20 years after i left Studer my memory isn't that good) but maybe you ask in detail what you need to know

Thank you very much.
I would like to know which pins should be connected directly between the Talkback Box (connector DB-50) to connectors in de 961, the AUX MONITOR CONNECTOR (DB-50) and STUDIO MONITOR CONNECTOR (DB-25). I have high resolution schemes of this part in PDF, may send them via e-mail?

Thank you again

Best regards

viewfinder

no - i don't need the schemas - have found now the better pdf file. but just follow the signal names - i think is's not so difficult... otherwise maybe somebody has an actual layout how to connect

Thanks, I'll try again

Best regards